CNC02-Continuously-Working Thermal Cutter
is available for
high point temperature adjustment,
16 sections of temp to set.

Peter Lin, cnc@cncGlass.com,
cnc@cncEVA.com
Whatsapp: 0086 15013829504,
WeChat: WeCan365
www.cncGlass.com www.cncEVA.com

Differences between CNC02 and CNC01:

*CNC02-Continuously-Working Thermal Cutter is designed for continuously working with air cooling system, while CNC01-Intermittently-Working is only for short time working, you need to release the button intermittently for cooling after short time heating in case itself gets too hot.

*CNC02-Continuously-Working is able to trim the edges with minimum of smoke and no burned marks.

*CNC02-Continuously-Working is lighter ,only 610g, easier to handle, while CNC01 is 950g.

*CNC02-Continuously-Working is available for high point temperature adjustment, 16 sections of temp to set. So you don’t need to let the blades going up to 500C degrees each time you use it, you may only set the lower temperature(for example about 300C degrees) only if it’s high enough for you to trim interlayer remains, so you can prolong the life time of the blades, and save cost.

Published by cnc@cncGlass.com EVA film glass interlayer

Contact Peter Lin Mail: cnc@cncGlass.com Whatsapp: 0086 15013829504 http://www.cncglass.com/eva-film/ Super clear eva film Outdoor white eva film series Green tape for laminating, heating resistant Thermal cutter trimming eva glass edges www.cncGlass.com www.cncEva.com www.cncNext.com www.c-n-c.com www.ucolin.com